Wire cutting magnetic fixture

November 06, 2018

When the workpiece with small blank is processed on the online cutting machine, it is not easy to clamp and correct, especially the verticality of the upper and lower sides is difficult to guarantee. To this end, we have designed a set of magnetic clamps for wire-cutting machines that work well. The specific method of the magnetic clamp shown in the figure is as follows: (1) Using a magnetic dial gauge holder, the upper and lower surfaces are ground to make them parallel. 2 Using a piece of plexiglass, the length and width are processed to be the same as the plane on the table. 3 Use electrician pure iron to make two pole boots, the shape is as shown. 4 with a piece of magnetic steel,