[Usage of carving knife] Usage and selection of carving knife
Used for: carving of PS board, PVC, acrylic, organic board, density board, copper, aluminum alloy, metal, hardwood, mahogany. 1. The unique material selection and perfect design combination of the AA-level single-edged spiral milling cutter improves your work efficiency to a greater extent while reducing the cost of cutting, milling and engraving. 2. Before using this product, the relevant data of the engraving machine must be adjusted and set to: (speed reference data: 24000r / min. Do not set the speed of the engraving machine below 20000r / min) (reference speed data: 2-8m / min), For low-power engraving machines (2.2 kW), the speed of the engraving machine must be set at the highest and the advance speed adjusted to the fastest. 3. The characteristics of the knife: (large row cutting, sharp, non-sticky, not easy to break the knife, fast processing speed, wide range of uses) (while improving work efficiency, the loss of the tool is smaller, not afraid of broken knife, the cutting process is more perfect) . 4. Scope of use: shank diameter φ3.175mm φ4mm is widely used for cutting and milling of dozens of materials such as acrylic, PVC, two-color board, aluminum-plastic board, copper board, zinc board, aluminum board, nylon, soft wood board, crystal board, Cutting plate thickness of 1-10mm is better with blade diameter φ2mm. 5. Cutting and milling of solid wood with high hardness (such as high-density board, MDF) is recommended to use shank diameter φ4mm or φ6mm plate thickness of 3 cm or more is recommended to use shank diameter φ6mm or φ8mm better cost performance. Note: If the engraving machine fixture is not concentric or the engraving machine speed and feed rate do not meet the requirements of the tool, it will appear: (broken knife, burr). Therefore, before using the product, check and debug the engraving machine to the best state. Computer engraving knife imported diameter 2.0 3.1754.0 single-edged knife Features: good chip removal, not easy to stick the knife, it is an ideal tool for cutting and processing thin plates and rapid engraving 1. For acrylic cutting, it is recommended to use AA series single-edge acrylic milling cutter. It is characterized by smokeless and tasteless, fast speed and high efficiency. If the processing surface needs to have a frosting effect, it is recommended to use a double-edged three-edged spiral milling cutter. 2. MDF cutting process (for advertising mold opening), it is recommended to use double-edged large chip evacuation spiral milling cutter, it has two high-capacity chip evacuation grooves, double-edge design, not only has a good chip removal function, Very good tool balance. Imported tools will perform better in terms of service life and processing efficiency. 3. For aluminum plate cutting, it is recommended to use a single-edge aluminum cutter. During the processing, the knife is not sticking, the speed is fast and the efficiency is high. 4. For precision small relief processing, round bottom sharp knife is recommended. 5. Cork, MDF, native wood, PVC, acrylic large deep relief processing, ball head milling cutter is recommended. 6. Processing requirements: No burr cutting on the upper and lower surfaces, single-edge and double-edge milling cutters are recommended 7. For metal engraving and processing, it is recommended to use a special flat bottom sharp knife for metal. 8.3D engraving process, use 3D engraving knife. 9. For high-density board and solid wood processing, it is recommended to use single-edge solid wood special milling cutter. 10. Straight groove milling cutter is recommended for the processing of multilayer boards. 11. The use effect of the lower cutter, no burrs on the upper surface of the processed products, and no rocking during processing. Lab Testing Equipment,Testing Equipment,Standars Test Equipment,Test Equipment Xinxiang Xin Ming De Machinery Co., Ltd. , https://www.xmdsieve.com