How to maintain the medium frequency spot welding machine
Co2 Tank Refill Regulator,Paint Gun Regulator,HPA Regulator,Paintball Regulator Gauge,Paintball Regulator SHIJIAZHUANG TOPA TRADING CO., LTD. , https://www.topahydraulic.com
1. Regularly (once a month) check the lube oil in the lubricator. When it is too low, please add oil. The more lean or better the oil for the sewing machine oil or the special cylinder oil, the better.
2. Before use, drain the water from the water filter. Note: If the water filter is too much water, or if the compressed air is too dirty, it will cause the solenoid valve to block or the cylinder seal wear with the cylinder to damage the solenoid valve and the cylinder.
3. The welder must work under the condition of cooling water, otherwise the welder (transformer, SCR, electrode) will generate heat, affect the service life of the welder, and even burn.
4. The welder must keep working in a dry environment.
5. The guide shaft and guide rod of the welder cylinder must be refueled regularly (plus one time per week). The oil injection hole is in the place marked with “Please fill oilâ€. There is no need for frequent refueling. Frequent refueling will make it overflow.
6. When the welding machine stops working or ends the work of one day, please turn off the power. The sequence is to first turn off the power switch of the welding machine, and then pull down the open switch. Remember not to directly close the open switch when the power to the welder is not turned off. This operation can easily damage the electronic components in the control box of the welder.